Victor 0645 Instrukcja Obsługi Pobierz pdf

Victor® Plunger-Style Mole Traps

Instructions

To Set & Place the Mole Traps:

1. To identify active mole tunnels, flatten out all

tunnels. Wait 24 hours. Tunnels that resurface are

most likely the active tunnels. Set traps in these

locations.

2. Make a depression in the roof of the main tunnel by

pressing down with your thumb.

3. Center the trap on the tunnel, with the trap pan

directly over the depression you’ve made with your

thumb.

4. Push trap down until spears have bottomed out.

5. Preset spear holes by plunging spears up and down until

they travel easily to the bottom on their own.

6. Before setting the trap, make sure the firing latch is

OUTSIDE the pan.

7. Holding the trap frame in place, rapidly pull upward on T

handle until the firing latch snaps over the pan. Ease

T handle down until latch catches.

8. Trap is set. If necessary, apply slight downward force

to ensure pan is fitting IN the thumb depression and

is contacting the roof of the tunnel.

9. Trap has fired. Remove mole.

NOTE: Safety pin should be reinserted whenever un-

sprung mole traps are removed from ground.

Strona 1

Victor® Plunger-Style Mole Traps Instructions To Set & Place the Mole Traps: 1. To identify active mole tunnels, flatten out all tunnels.

Brak uwag

Victor 0645 Instrukcja Obsługi